const int buttonPin = 0; // Assuming BUT1 is connected to GPIO 0
const int ledPin = 8;    // Assuming the user LED is connected to GPIO 8
//test1
void setup() {
  Serial.begin(115200);
  Serial.println("Setup started");
  pinMode(buttonPin, INPUT_PULLUP); // Set the button pin as input with an internal pull-up resistor
  pinMode(ledPin, OUTPUT);          // Set the LED pin as output
  Serial.println("Setup completed");
}

void loop() {
  int buttonState = digitalRead(buttonPin); // Read the state of the button

  if (buttonState == LOW) {
    Serial.println("Button is pressed");
    digitalWrite(ledPin, HIGH); // Turn on the LED
  } else {
    Serial.println("Button is not pressed");
    digitalWrite(ledPin, LOW);  // Turn off the LED
  }

  delay(2000); // Add a 2-second delay between readings
}